Some questions

[dk3]

I've mapped quite a lot for cs 1.6, and I would like to give it a try at cspromod :)

So I just wanted to ask some questions.

Should I use the Source SDK? Because when I use mine i have a strange error. My brushes don't appear in 3d view.. I have it textured and i tried all the other settings and they don't show up.

If I can use the "normal" hammer (which I use for 1.6), can someone give me a link for the .fgd that's most used?

[onek]

Could it be how you have set up hammer? Its the only thing I can think of, other than that it could be your graphics card settings but don't take my word for it im a bit of a noob. :lol:

[dk3]

I don't have a clue :D

I don't remember configurating it. Didn't it come configurated already? Or maybe I did it a long ago..

[onek]

It should ask you to configure it first time you run it, if you launch source sdk then select the source 1 engine froim the drop down box and select counter strike source, then launch hammer, it should ask you to configure, try reconfiguring, or you could of possibly accidently hit at tab on the toolbar that disables textures in 3D world view.
Anyhow mate good luck on finding the solution. :D

[dk3]

Well I started reinstalling it. But I think it was all ok because I checked it. But mapping for cspromod is the same as mapping for source correct?

[onek]

You indeed are correct, im doing map remakes, im working on office, so your welcome to join the club of map remaking, not official one like but unofficially. :D :)

[dk3]

I got it to work =)